純水溶氧分析儀(感測器加控制器) Orbisphere K1100 LDO Sensor Kit, 0-2000 ppb, 410 controller, ¼" flow chamber, panel mount
產品編號：K1100-KTO-P-IMP
The original maintenance-free optical oxygen sensor for power plants. The original maintenance-free optical oxygen sensor for power plants. 免維護的電廠純水溶氧監測儀
Pre-configured Kit containing high accuracy Luminescent Dissolved Oxygen sensor K1100-S00, controller 410K/P1C00000, 3 m cable, ¼" flow chamber. Specially designed for power plants (non-nuclear). 預配置套組包含高精準度光學溶氧感測器 K1100-S00、控制器 410K/P1C00000、3 公尺電纜和 1/4 英吋 flow chamber。專門為發電廠純水應用而設計。
The Orbisphere K1100 optical sensor together with the Orbisphere 410 controller offers a new way of monitoring oxygen in power plants. Orbisphere sensors set the industry standards for oxygen measurement by offering peace of mind to every water chemist.
Applications 應用 : Ultrapure Water 超純水
Parameter 分析參數 : Oxygen
Certifications 認證 : 2004/108/EC - EN 61326-1
Range 量測範圍 : 0 - 2000 ppb dissolved O₂ (DO)
Accuracy : ± 0.8 ppb or 2 % whichever is greater
Lower Limit of Detection (LOD) : 0.6 ppb
Repeatability : ± 0.4 ppb or 1 % whichever is greater
Reproducibility : ± 0.8 ppb or 2 % whichever is greater
Response Time : (90%) <10 s (gas phase); <30 s (liquid phase)
Calibration 校正 : Single point zero calibration
Sample Flow Rate : 50 - 300 mL/min
Sample Pressure : 1 - 20 bar absolute (14.5 - 290 psi)
Sample Temperature : -5 - 50°C (23 - 122°F)
Temperature Range :
Accurate from -5 - 50 °C (23 - 122 °F)
Resistant - temperature from -5 - 100 °C (23 - 212 °F)
Communication Capabilities 通訊傳輸 : 3 x 0/4-20 mA; RS485; Ethernet
Analog Outputs 類比輸出 : 3 Smart 0/4 to 20 mA (500 Ohms) programmable as linear or tri-linear, configurable to send diagnostics or alarm informations.
關鍵字: 純水 DO sensor, Dissolved Oxygen sensor, 純水含氧量感測器, 超純水 溶氧分析儀, 純水 溶氧監控, 超純水 溶氧 監測儀
Pre-configured Kit containing high accuracy Luminescent Dissolved Oxygen sensor K1100-S00, controller 410K/P1C00000, 3 m cable, ¼" flow chamber. Specially designed for power plants (non-nuclear). 預配置套組包含高精準度光學溶氧感測器 K1100-S00、控制器 410K/P1C00000、3 公尺電纜和 1/4 英吋 flow chamber。專門為發電廠純水應用而設計。
The Orbisphere K1100 optical sensor together with the Orbisphere 410 controller offers a new way of monitoring oxygen in power plants. Orbisphere sensors set the industry standards for oxygen measurement by offering peace of mind to every water chemist.
Applications 應用 : Ultrapure Water 超純水
Parameter 分析參數 : Oxygen
Certifications 認證 : 2004/108/EC - EN 61326-1
Range 量測範圍 : 0 - 2000 ppb dissolved O₂ (DO)
Accuracy : ± 0.8 ppb or 2 % whichever is greater
Lower Limit of Detection (LOD) : 0.6 ppb
Repeatability : ± 0.4 ppb or 1 % whichever is greater
Reproducibility : ± 0.8 ppb or 2 % whichever is greater
Response Time : (90%) <10 s (gas phase); <30 s (liquid phase)
Calibration 校正 : Single point zero calibration
Sample Flow Rate : 50 - 300 mL/min
Sample Pressure : 1 - 20 bar absolute (14.5 - 290 psi)
Sample Temperature : -5 - 50°C (23 - 122°F)
Temperature Range :
Accurate from -5 - 50 °C (23 - 122 °F)
Resistant - temperature from -5 - 100 °C (23 - 212 °F)
Communication Capabilities 通訊傳輸 : 3 x 0/4-20 mA; RS485; Ethernet
Analog Outputs 類比輸出 : 3 Smart 0/4 to 20 mA (500 Ohms) programmable as linear or tri-linear, configurable to send diagnostics or alarm informations.
關鍵字: 純水 DO sensor, Dissolved Oxygen sensor, 純水含氧量感測器, 超純水 溶氧分析儀, 純水 溶氧監控, 超純水 溶氧 監測儀
One calibration per year 每年一次校正
One zero point calibration per year is all that is needed with the K1100 sensor. Designed for minimal drift, luminescent technology makes the K1100 sensor the most stable sensor with the longest calibration interval in the industry.
K1100 感測器每年只需進行一次零點校正。 K1100 感測器採用光學技術，漂移極小，是穩定度最高、校正週期最長的感測器。
No membranes = two minutes of maintenance 無需膜片 = 兩分鐘維護
With no membranes to replace and no electrolyte solution to replenish, the K1100 requires only two minutes of maintenance per year. Corrosive or hazardous chemicals are not required, making the annual task faster, easier and safer without reducing measurement precision. 無需更換膜，也無需補充電解液，每年只需兩分鐘維護。無需使用腐蝕性或危險化學品，讓年度維護工作更快、更輕鬆、更安全，且不會降低測量精準度。
Low cost retrofit 經濟效益
The complete system consists of a controller, a flow chamber, and the K1100 Luminescent Dissolved Oxygen sensor. The sensor is compatible with Hach Orbisphere 28 mm flow chambers, eliminating the need for engineering changes. Installation is fast and easy and does not require special preparation. 整套系統以控制器、flow chambers 以及 K1100 光學溶氧感測器運作。溶氧感測器與 Hach Orbisphere 28 mm flow chambers 相容，無需進行任何工程改造。安裝快速簡便，無需特殊準備。
A new level of confidence 高水準的可靠度
The K1100 optical sensor is the first to use luminescent measurement technology to measure both ppb and ppm oxygen levels in power plants. Since 1978, Hach Orbisphere sensors have set the industry standard for oxygen measurement by delivering confidence to every water chemistry manager. The K1100 maintains this tradition and offers significant operating and cost benefits. K1100 光學感測器是首款採用光學技術測量電廠中 ppb 和 ppm 等級氧氣濃度的水質分析感測器。卓越的性能協助每位水質化學管理人員獲得可靠的測量結果，大幅提升運作效率和成本效益。
One zero point calibration per year is all that is needed with the K1100 sensor. Designed for minimal drift, luminescent technology makes the K1100 sensor the most stable sensor with the longest calibration interval in the industry.
K1100 感測器每年只需進行一次零點校正。 K1100 感測器採用光學技術，漂移極小，是穩定度最高、校正週期最長的感測器。
No membranes = two minutes of maintenance 無需膜片 = 兩分鐘維護
With no membranes to replace and no electrolyte solution to replenish, the K1100 requires only two minutes of maintenance per year. Corrosive or hazardous chemicals are not required, making the annual task faster, easier and safer without reducing measurement precision. 無需更換膜，也無需補充電解液，每年只需兩分鐘維護。無需使用腐蝕性或危險化學品，讓年度維護工作更快、更輕鬆、更安全，且不會降低測量精準度。
Low cost retrofit 經濟效益
The complete system consists of a controller, a flow chamber, and the K1100 Luminescent Dissolved Oxygen sensor. The sensor is compatible with Hach Orbisphere 28 mm flow chambers, eliminating the need for engineering changes. Installation is fast and easy and does not require special preparation. 整套系統以控制器、flow chambers 以及 K1100 光學溶氧感測器運作。溶氧感測器與 Hach Orbisphere 28 mm flow chambers 相容，無需進行任何工程改造。安裝快速簡便，無需特殊準備。
A new level of confidence 高水準的可靠度
The K1100 optical sensor is the first to use luminescent measurement technology to measure both ppb and ppm oxygen levels in power plants. Since 1978, Hach Orbisphere sensors have set the industry standard for oxygen measurement by delivering confidence to every water chemistry manager. The K1100 maintains this tradition and offers significant operating and cost benefits. K1100 光學感測器是首款採用光學技術測量電廠中 ppb 和 ppm 等級氧氣濃度的水質分析感測器。卓越的性能協助每位水質化學管理人員獲得可靠的測量結果，大幅提升運作效率和成本效益。