實驗室水中總有機碳分析儀 QbD1200+ Lab TOC Analyzer
產品編號
QbD1200+ 實驗室TOC分析儀採用UV紫外線燈+過硫酸鹽氧化方法,量測範圍為0-100 ppm,數位NDIR 檢測儀保持長期穩定性,適用於製藥、電力、疾病管控、自來水等水樣濃度較低的產業,極佳的重複性,可靠的測量結果,操作簡單維護容易,使用成本較低,節省客戶時間,滿足相關藥典和法規,大幅解決長久以來困擾客戶的問題,例如: 低濃度TOC測量時會出現重複性差,使用成本高,維護複雜及校正時間長等問題。QbD1200+實驗室TOC分析儀讓客戶的關鍵測量變得簡單易行。
應用 : 製藥、電力、疾病管控、自來水等產業
符合全球主要藥典規定,包括:USP、JP、EP、IP、KP、ICH
簡化的 IQ / OQ / PQ 認證程式符合 ICH 指導原則
自動校正,自動進行系統適用性測試,自動產生報告

Hach QBD1200+ is a laboratory TOC analyzer that supports a wide range of TOC measurements from ultrapure and pharmaceutical water to cleaning validation.
Hach QBD1200+ addresses common issues faced by testers in TOC measurement. It eliminates the need for extensive preparation before testing, reduces measurement time, and minimizes the costs associated with reagents. The device ensures stable and accurate TOC values, eliminating dispersion and providing reliable measurement results. Additionally, calibration processes are made easier and less risky, further enhancing the efficiency and effectiveness of TOC testing. Overall, the Hach QBD1200+ is a valuable tool for laboratories and industries that require precise and efficient TOC measurement.

簡單易用的操作和維護
● 10.4英寸彩色觸控式螢幕,直覺式使用者操作界面
● 導引式軟體界面,儀器操作更加簡單易用
● 自動調整測量範圍/稀釋功能,讓使用者不必提前得知樣品濃度也能完成測量
● 僅需一種試劑即可完成相關測量和分析(自行配置或向Hach採購)
● 簡單方便的無紙化功能,可向受到Windows安全性原則管理的網路共用目錄匯出資料

關鍵字 : Lab TOC 分析儀, 實驗室 純水 TOC 分析
產品介紹
Wet oxidation laboratory TOC analyzer with high accuracy and reproducibility compatible with 3 stations
QBD1200+ can measure TOC with high precision and reproducibility from ultrapure water of less than 1ppm to TOC of raw water up to 100ppm.
 
Reduces operating costs compared to conventional TOC meters
QBD1200+ can be operated stably with only an annual inspection. There is no need to calibrate the calibration curve, which has been routinely performed in the past. Running costs can be reduced with low reagent costs and simple maintenance work.
 
Supports data integrity without using management PC. Easy operability with 10.4- inch touch panel
The QBD1200+ allows configuration and report data management without a PC. Anyone can easily set up the operation of the TOC meter, and it excels in data integrity measures.
 
Startup is quick and daily inspections are smooth
In the case of a general TOC analyzer, it takes 2 to 3 hours for preparation before measurement, including startup, daily inspection, line cleaning, calibration curve test, and system suitability test. However, Hach Ultra's QBD1200+ only needs to perform a daily inspection called a background test that only confirms that the TOC value of the oxidant reagent is less than 100 ppb because of its fast start-up responsiveness. It is possible to start measurement in minutes, which greatly reduces the tester's process.
 
Compact design for easy lab installation
The QBD1200+ has a compact design that makes it easy to install in the lab.
QBD1200 + body: 320 mm (W) x 507 mm (D) x 410 mm (H)
Autosampler: 366 mm (W) x 537 mm (D) x 457 mm (H)
 
 
效能規格  
測量範圍
0 ~ 100 ppm
精度
<2% 或 3ppb(以較大值為准)
準確度
± 3%(≥500ppb)
校正週期
約2小時
分析時間
最快約4分半鐘
 
測量方法
氧化
UV(紫外線)燈 + 過硫酸鹽
UV燈確認
寬頻矽酸鹽光電二極體感測器
檢測器
數位 NDIR
檢測器穩定性
按參考值持續不斷地驗證
檢測器濕氣預清除
Peltier 冷卻器,採用連續電流監控
分配器模組
採用注射泵,精確到體積的 +/-1%
流量感測器
動態流體感測器(可確保樣品和試劑體積的精確度)
載氣的選擇
高純空氣、氧氣或氮氣
載氣壓力的確認
雙孔口壓力感測器
載氣閥門的關閉
測量完成後閥門就會關閉,以避免浪費氣體
自動量程功能
分析模式
NPOC(不可吹掃有機碳)
 
自動進樣器
容量
64個採樣瓶(40mL玻璃小瓶TOC)
樣式
XYZ,隔片穿孔
樣品盤材質
鋁陽極氧化
 
儀器尺寸
寬320 x 深507 x 高410 mm
電源
100-240 VAC,50/60 Hz,2A
重量
14千克(31磅)
自動採樣器尺寸
寬366 x 深537 x 高457 mm
電源
100-240 VAC,47-63Hz
重量
21千克(45磅)
工作溫度和濕度
5-35℃;相對濕度高達90%,非冷凝
報告所用單位
ug/L (ppb)